HC40E
Voltage range: DC 4.5V ~ DC 24V
Current range: 0.1A ~ 3.8A
Head range: 0.5M ~ 15M
Flow range: 100L / H ~ 3600L / H
Power range: 0.5W ~ 86.4W
Operating temperature: -35 degrees Celsius -100 degrees Celsius
Job requirements: continuous non-stop (must ensure that there is water)
Noise: ≤ 40dB or 35dB (1 meter distance)
Waterproof: fully waterproof (waterproof rating IP68), diving installation can also be installed externally
Speed regulation (adjustable flow, adjustable head): only applies to three-phase brushless DC pump
Features:
1. Long life, no maintenance, small size, high efficiency, low power consumption, anti-interference ability, smooth operation
2. No carbon brush, no pollution, electronic commutation, long life.
3. Motor stator and circuit board part of the use of epoxy potting and complete isolation with the rotor to solve the motor-type DC pump long-term diving leakage problems can be installed underwater and completely waterproof
4. Pump parameters can be modulated, 24V pump can be modulated 2 meters head, but also 7 meters head, the same volume, wide voltage operation.
5. Pump shaft with high-performance ceramic shaft (lower cost optional stainless steel shaft), high precision, good wear resistance, due to the use of high-precision pump sleeve and ceramic shaft (to reduce the cost of other materials) with the precision, noise Low, power less noise can even reach 30 dB below.
6. Three-phase non-Hall program-driven DC pump can achieve PWM speed control, analog signal (0 ~ 5V) speed, potentiometer VR manual speed, so you can adjust the flow and head.
7. Three-phase direct current pump for the soft start, no impact, start power consumption is small, the circuit board and the pump completely separated, the pump which does not have any electronic components, the pump body with high temperature materials, water pump can be 100 degrees in the water temperature use. With impeller rotor stuck protection, reverse protection, overload protection, overcurrent protection.
8. Water pump interface is rich, 4 points thread, 2 points thread, out of 8mm, 10mm, 22mm, 27mm and so on.
9. If you want to increase the pump head can also pump in series, the head can be doubled.
9. Amphibious (topical installation position below the liquid level)
